How to send Timecode output

Refer to Manual Sections:

Chapter 36 Timecode Support

36.6 Timecode Generation

15.14 Cue Stack Macros

Step By Step

  • Enable Timecode output go to "Setup"
  • Then "View Settings"
  • Select the "MIDI Timecode" tab
  • Set your framerate
  • Select the Type of Timecode you would like to send (Note - What types of Timecode you can send will depend on your hardware)
  • Once that is set, you can create a cue with a Cue Stack Macro to start and stop timecode. Format is Q<time code time you want to start with> to stop timecode use W0 (Wzero)
Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.

Still need help? Contact Us Contact Us