QuickQ Console -> GeNetix - 10Scene Wall Station: Quick SetUp

  • Connect the QuickQ Console to GeNetix GN5 or GeNetix GN10 via Cat5 network cables (direct or via an unmanaged* switch).
  • Connect 10Scene Wall Plates to GeNetix via Cat5e solid core cable to Wall Plates.
  • Connect Fixtures to GeNetix via DMX cable.

GeNetix Device

  • Main Menu>Quick Setup: Set network protocol and DMX output as needed.
  • Main Menu>IP Setup: Accept default of 10.
  • Main Menu>10Scene Mode: Set to Gateway.

Consoles Settings

  • Settings>Network>wired: Accept the IP defaults, 10.0.0.X and 255.0.0.0 scheme. Check that the IP is NOT the same as the GeNetix device's.
  • Settings> DMX: For each universe, set Send Over Network to match either Art-Net or sACN, as chosen for the GeNetix device.
  • Settings>Network Devices: Use (Configure Device) to configure the GeNetix device to work for the console settings.
  • Settings>10Scene>Settings: Choose 10 scene toggles and execute 1-10 on and off AND Enable Gateways.
  • Settings>Execute: Set grid size to 10x10 and record 10scene scenes to executes first row.

*Unmanaged switch preferred. Managed may require switch configuration.


Testing and working with QuickQ V11 and GeNetix V2.2 Fri, Apr 4, 2025

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.

Still need help? Contact Us Contact Us