QuickQ Setup a Wifi Router to extend wirelss to remote app

1. Connect your wireless router LAN port (not the WAN) to the QuickQ device's network port with a Cat5 cable. If you are using the network on your QuickQ for lighting protocol output, you will need to add an unmanaged switch to allow connection to your lighting and to the wireless router.
2. QQ console Settings > Network Wired: configure to a 10.0.0.X and 255.0.0.0 IP and subnet scheme.
3. Setup your chosen wireless router with a static IP address of 10.0.0.1 and a subnet of 255.0.0.0 see this article or similar.
4. Disable security settings on your wireless router (only use this wireless router for lighting and the security will be provided by the console password). You can add security options if desired once you have the wireless setup and tested as working.
5. Connect your table or phone with the QuickQ remote app on it to the wireless router by setting a fixed IP on the tablet or phone with an IP of 10.0.0.Y and a subnet of 255.0.0.0.
6. Open the QuickQ app on the device once connected and choose manual IP in the connection type.
7. Enter the IP address you used for the console in #2 10.0.0.X