Removing Secondary Video Card MQ100 Pro 2014

Suspected Faults:

  • Screen issues on boot
  • Unable to boot.

It is possible that either the video card has failed or has come loose. If instructed by ChamSys USA technical support perform the following to check/test.

Remove back panel

To remove the rear panel remove the nine screws around the three edges using a posidrive screwdriver. Powered tools are NOT recommended.

Remove the connectors to the two console work lamps by pulling down to disconnect. Move the panel forward away from the console. It should be possible to access the secondary video card on a Pro 2010 without disconnecting any other connectors.

The secondary Video card is identified below.

Pull the metal clips on either side of the card and gently lift the card and pull towards the front of the console. Remove the card, reassemble the console and test.

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.

Still need help? Contact Us Contact Us